INFO: Security level for “outside” set to 0 by default.Įxecuting command: ip address dhcp setroute
Verify there is a valid image on disk0:/ or the system willīegin to apply factory-default configuration:Įxecuting command: interface Ethernet 0/0Įxecuting command: switchport access vlan 2Įxecuting command: interface Ethernet 0/1Įxecuting command: switchport access vlan 1Įxecuting command: interface Ethernet 0/2Įxecuting command: interface Ethernet 0/3Įxecuting command: interface Ethernet 0/4Įxecuting command: interface Ethernet 0/5Įxecuting command: interface Ethernet 0/6Įxecuting command: interface Ethernet 0/7 The first image found in disk0:/ will be used to boot the WARNING: The boot system configuration will be cleared. Pool size is reduced to 250 from the platform limit 256 WARNING: DHCPD bindings cleared on interface ‘inside’, address pool removedĬiscoasa(config)# configure factory-defaultīased on the inside IP address and mask, the DHCP address Hardware: ASA5505, 512 MB RAM, CPU Geode 500 MHz Also the ‘configure factory-default’ includes the http commands to enable ASDM access as defaultĬiscoasa(config)# show version | inc Hardware I think this is wrong – I believe the answer is D, you use the ‘switchport access vlan ’ command as the 5505 uses an 8-port switch for it’s interfaces.